A large number of different cables, adapters and peripheral simulations are used in the engineering of vehicle electronics, the testing of electronic and electrical components and in component integration into the complete vehicle.
The use of standard products is rarely possible here. Test equipment specially adapted to the control unit, vehicle series or test environment is nearly always required.
Nevertheless, the modular system established and introduced at Softing makes it possible for cables, adapters and other test equipment to be realized extremely flexibly and at the same time cost-effectively – always tailored to the specific requirements and the concrete application.
Our many years of experience in engineering and setting up test equipment pays off. Our solutions are compelling thanks to their durability, quality and maximum reliability.
These include vehicle connectors, connectors for measuring, load or supply lines, and much more.
Our adapters guarantee safe contacting between electronics and tester. On request, the design for very high contact cycles is possible at any time.
The break-out boxes make it possible to disconnect practically all cables connected to the control unit connector individually or to connect them to measuring systems for measuring purposes.
With the distribution box, individual IO signals as well as ECU data traffic can be reliably measured, recorded or also connected to suitable remote stations.
Lab cars are similar to the distribution box for accessing IO signals and ECU communication - but extended by integrated load simulations, sensor or actuator equivalent circuits or even communication counterparts.
These include, for example, measurement adapters and break-out boxes, error and residual bus simulation, and much more.